You must give a breath sample before placing keys in ignition.
Press green button to turn on unit.
Digital screen will read (WARM UP) (PLEASE) (WAIT) (SERV #)
Once the screen reads (BLOWNOW)
Take in deep breath and then blow steady into mouth piece.
As you are blowing, the unit will make a low tone buzz.
Continue to blow until the unit gives a single beep.
You will then have a short pause, followed by a double beep.
Once you hear the double beep you will give a one second hum into the mouth piece, it is important to not blow air when doing the hum.
The unit will then read (ANALYZING).
Then either (PASS) or (FAIL)
Once you receive (PASS) it will then read (START VEHICLE)
Parking Vehicle:
Once you shut off your vehicle the unit will read (IGNITION OFF) (OK) (TO UNPLUG).
If you decide to disconnect your handset and take it with you do not unplug handset until the screen goes blank and the unit is then powered off.
If you decided to leave the unit in the vehicle, place unit in a safe place where direct sun light will not hit the handset.
Random Retest:
You will see the first random retest within 5 to 15 minutes after starting vehicle and 15 to 45 minutes for everyone after the first.
While driving the screen will read (BLOW NOW) and a countdown clock comes on that starts off at 360 seconds and counts down from there.
Take in deep breath and then blow steady into mouth piece.
As you are blowing, the unit will make a low tone buzz.
Continue to blow until the unit gives a single beep.
The unit will then read (ANALYZING).
Then either (PASS) or (FAIL)
Then the screen will go blank until another retest is required.
It is very important to take every retest!
If any retests are missed within your service period, your days will drop to -1 and you will have to call in and schedule an early service appointment and will be charged a violation reset fee.
Over Temp:
When powering the unit the screen reads (WARMUP) (PLEASE) (WAIT) (OVERTEMP).
You will want to press and hold the green button unit the screen reads (RESET)
Once you see reset release the green button and then power on unit again and you find the over temp has been cleared.
Fails:
When giving a breath sample the screen reads (FAIL) your B.R.A.C. or (Breath Alcohol Content) is within .03 to .05
If the screen reads (VIOLATION) your B.R.A.C. is over a .08
Any violation fails occur within your service period your days will drop to 6 days and you will have to call and make an early service appointment and will be charged a violation reset fee.
Perm Lock:
A perm lock will occur if you allow your days to go past -6 days.
If a perm lock occurs you will need to call and schedule an appointment to have your handset reset and will be charged a violation reset fee.
